Why is my Kubota Lawn Mower discharge chute plugged?
If your Kubota Lawn Mower discharge chute is plugged, it could be because the grass is too wet, so wait for it to dry. If the grass is too long, raise the cutting height and cut the grass twice. Avoid cutting too low by raising the cutting height. Make sure the engine rpm is not too low and mow at full throttle. Finally, avoid ground speed too fast and slow down.
Why is my Kubota Z726X Lawn Mower machine operation not smooth?
If your Kubota Lawn Mower is not operating smoothly, it could be due to insufficient hydrostatic transaxle fluid, so replenish the oil. If the filter is clogged, replace it. If the transaxle bypass lever is activated, deactivate it.
Why is my Kubota Z726X belt slipping?
If your Kubota Lawn Mower mower belt is slipping, the tension spring might be weak, so replace it. Also, the mower belt could be worn, so replace it. The mower might be plugged, so unplug and clean the mower deck. Finally, check for debris in the pulleys and clean them.
What to do if Kubota Z726X does not move while engine is running?
General| Cutting Width | 54 inches |
|---|---|
| Transmission | Hydrostatic |
| Cutting Height | 1.5 - 5 inches |
| Number of Blades | 3 |
| Drive | 2WD |
| Displacement | 726 cc |
| Turning Radius | Zero-turn |
| Deck Material | Steel |
| Deck Type | Fabricated |
| Warranty | 2 years |
Indicates an imminently hazardous situation.
Indicates a potentially hazardous situation.
Indicates a potentially hazardous situation.
Indicates equipment or property damage.
Gives helpful information.
Read and understand manual before operating machine.
Procedures for safe operation on slopes.
Levers controlling machine movement and steering.
Roll-Over Protective Structure for safety.
Step-by-step instructions for attaching the mower deck.
Procedures for starting the engine.
Position levers for safe starting.
Monitoring machine status during operation.
Conditions requiring immediate engine shutdown.
Procedures for jump starting a dead battery.
Steps to safely shut down the engine.
Instructions for using the foldable Roll-Over Protective Structure.
Step-by-step instructions to fold the ROPS.
Step-by-step instructions to raise the ROPS.
Procedures for starting the machine.
Proper use and importance of the seat belt.
Operating the machine using motion control levers.
Operating the machine forward and in reverse.
Procedures for safely stopping the machine.
Adjusting the mower deck cutting height.
Engaging and disengaging the Power Take-Off.
Procedures for starting the mower.
Schedule for routine maintenance tasks.
Chart detailing periodic service tasks and intervals.
Pre-operation checks for the machine.
Procedure to check and maintain engine oil level.
Fuel checking and refueling procedures.
Checking and maintaining the transaxle fluid level.
Maintenance tasks every 50 hours.
Testing engine start system safety features.
Testing the Operator Presence Control system.
Maintenance tasks every 100 hours.
Inspecting fuel lines and filter for wear and clogs.
Adjusting the parking brake for proper function.
Assessing battery health and charging needs.
Diagnosing and correcting engine problems.
Diagnosing and resolving battery issues.
Troubleshooting issues with the machine's operation.
Troubleshooting problems related to the mower deck.
To Next Page
