2
Manufacturer’s address: KUHN-AUDUREAU S.A., B.P. 19, F-85260 LA COPECHAGNIERE
IMPORTANT INFORMATION
The KUHN machine that you have just purchased has undergone a full range of inspections throughout
the manufacturing process. If you should encounter a fault in spite of all the care given to the manufac-
ture of your machine, please contact your dealer who will solve the problem with the assistance of our
after-sales service.
To enable us to satisfy your requirements, please provide the information below when you call us. It
will only take you a few minutes to fill in this page when your machine is delivered but it will save you
a lot of time in the event of a problem.
1- GENERAL DATA
Note the machine references here.
KUHN
PRIMOR
Type of machine Sequence number in the series Date commissioned
2 - OPTIONAL EQUIPMENT
Tick the boxes corresponding to the options fitted to your machine.
Electric control Wide angle PTO shaft
Rectangular bales kit Chute type of standard Primor on Primor PH
Sealed floor Category 2/3 linkage bar
To Next Page
Loading...
