EN EN
1.Long press the power button to turn it on/off.
2.Short press the power button once to switch gears, which are divided into three gears.
3.Short press the single and dual drive buttons once to switch between single and dual drive modes.
4.Press the power button three times in a row to enter the menu setting interface. The instrument panel will
display P1, P2, P3, P4, P5, P6, P8, PA, PB.
P01: Kilometer/mile selection settings (default is kilometers).
P02: Voltage level setting, 36V/48V/52V/60V/72V (default value is 60V).
P03: The unit of wheel diameter is inch, which can be set to 080-160 (default is 120).
P04: Speed measurement magnetic pole range: 1-100, (default is 30).
P05: Cruise selection, 0 is no cruise, 1 is cruise, (default is no cruise).
P06: Zero start/non zero start settings, 0 is zero start, 1 is non zero start, (default is zero start).
P08: For the setting of sleep time, 0 is not sleep, and other numbers are sleep time (default is 5 minutes).
PA: Starting force setting, 1-5, 1 minimum, 5 maximum.
PB: For the braking force setting, it is from 0-5, 0 is turned off, and the braking force of 1-5 gradually increases.
From the date of receipt to the warranty period, if this product occurs malfunctions or is damaged,it can be
repaired, exchanged, or returned for free after being tested and confirmed by the KuKirin after-sales center. When
applying, please contact the product seller and follow the instructions. At that time, you need to provide accurate,
complete,and valid purchase information or invoices.
Reminder: The charger indicator light is red when charging, and green when fully charged.
Retry after replacing the rear motor/controller.
Retry after replacing the rear motor/controller.
Try again after replacing the throttle.
Try again after replacing the controller.
The battery is low.Please charge it and try again.
It belongs to instrument reception failure. Please replace the instrument/-
controller and try again.
It belongs to instrument reception failure. Please replace the instrument/-
controller and try again.
The temperature of the controller is too high.Please check if the
controller is fixed/heat dissipation is good.
Please replace the controller and try again.
It belongs to instrument reception failure, please replace the instrument/-
controller and try again.
Fault SolutionCode
E001
E002
E003
E005
E006
E007
E009
E0011
E0013
E0017
Rear motor Hall fault
Accelerator malfunction
Controller reception failure
Under-voltage
Receiving fault
Sending fault
Controller over
temperature protection
Front motor Hall fault
Controller failure
Controller reception failure
Warranty content
Controller, instrument, motor, lithium battery, charger
Frame, front body, rear wheel hub, brakes,folding,body lever, front fork,
brake system, throttle dial,etc.
Warranty period
Half a year
1 year
8.Operation instruction
9.Troubleshooting
10.Battery charging
11.Warranty
Display device
Accelerator
Handle grip
Brake handle
Switch
Switching between single
and dual drive
Loudspeaker
Turn signal
Headlight
Left turn Speed
Brake sign
Right turn
Speed limit indicator box
Gear
Speed unit
Mileage/Fault code
Cruise signs
Non-zero start
Single drive
Double drive
Voltage
Battery level
Headlight sign
Open the waterproof plug
for charging
After charging,
tighten the waterproof plug
11.Warranty
To Next Page
Loading...
