All indicators twinkle
simultaneously
1. Water tray is blocked by
ice cube
2. The motor is stuck, or
the motor falls off, or the
motor is damaged
3. Micro switch damaged
1. Unplug the power to take out the ice
which blocking the tray, then plug the
power and press the POWER button,
the machine will restart 3minutes later.
2. Call the service hotline
The machine has been
working, but the water
has been warming
Solenoid broke down
1. Replace the solenoid valve
2. Call the service hotline
When the ice is full, the
machine does not display
the ICE FULL Icon
1. Ice full sensor damaged
2. Solar light interference
1. Replace the ice full sensor
2. Making ice indoor
3. Call the service hotline
PROBLEM POSSIBLE CAUSE SUGGESTED SOLUTIONS
The compressor works
abnormally with a
buzzing noise
The voltage is lower than
recommended
Stop the ice maker and do not restart
until the voltage is normal.
Water shortage indicator
light is on
1.There is no water
2.The pump is full of air
1.Add to some water until it reaches
MAX position
2.Press POWER button to restart
Indicator lights on display
are not on
Blown fuse/ No power Replace fuse/Turn power on
The ice made is too large
and with pieces sticking
together.
Ice of previous cycles left in
the water tray
Take out the ice under the standby
state
The ice making process
was correct, but no ice
came out?
1. The compressor has no
refrigerant
2. Compressor damaged
Fan motor damaged
Call the service hotline
To Next Page
Loading...
