Kurzweil Forte SE - The Pedal Jacks

The Rear Panel
The Pedal Jacks
5
GETTING STARTED GUIDE
For other MIDI connection scenarios, please refer to the Forte SE Musicians Guide.
The Pedal Jacks
Use the three pedal jacks to connect controller pedals to the Forte SE.
Switch Pedals
1/4 inch tip-sleeve (mono) plug or, 1/4 inch tip-ring-sleeve plug
congured as dual switches (TS and RS) or 2 terminal continuous
pedal (half-damper).
Continuous Control
(CC) Pedals
10 kΩ linear-taper potentiometer, 1/4 inch tip-ring-sleeve (stereo)
plug with the wiper connected to the tip.
e default function of each pedal can be changed for all Programs and Multis by setting a pedal
override on the Global Control Overrides page in Global Mode. Pedals are also independently
assignable within each Program or each Zone of every Multi.
Here are the default control settings for the ve pedals used by Forte SE:
SW 1a Pedal Sustain (MIDI 64)
SW 1b Pedal Sostenuto (MIDI 66)
SW 2a Pedal Sostenuto (MIDI 66)
SW 2b Pedal Soft (MIDI 67)
CC Pedal Expression (MIDI 11)