Kurzweil K2000 User Manual

SECTION 2
K2RVOLTS.OOC 01/05/93
2.20 K2000R FUSES
WARNING:
FOR
CONTINUED PROTECTION AGAINST THE RISK OF FIRE, REPLACE FUSES
ONLY WITH THE TYPE AND RATING SPECIFIED.
2.20.1
Fuse Replacement
The fuse compartment is located in the power module and directly beneath the
AC connector, under a clear cover. The fuse can be inspected through this
cover.
2.20.2
To replace a fuse:
• Disconnect the AC line cord.
• Slide the clear plastic cover up (over the AC connector)
• Locate the Fuse Removal Lever labeled "Fuse Pull" and raise this lever
until the adjacent fuse is free of its clip mount. Remove the fuse.
• Insert the new fuse and press completely into the clip mount.
• Close the clear plastic cover and reconnect the AC power cord.
• Test the unit for proper operation.
IMPORTANT INFORMATION
In North America and other locations where the AC mains supply voltage is 100
- 120V/60Hz, replace the fuses only with:
Type GMC, 5rnrn x 20rnrn, Time-Delay, 250 Volt, 1.25 Amp fuse
In Europe and other locations where the AC mains supply voltage is 220 -
240V/50Hz, replace the fuses only with:
Type GDC, 5rnrn x 20rnrn, Type T (Time-Lag), Low-Breaking Capacity, 250
Volt, .63 Amp fuse
22

Kurzweil K2000 Specifications

General

Type	Digital Synthesizer
Polyphony	24 voices
Weight	35 lbs
Year Released	1991
Waveforms	Sample-based, user loadable
LFO	Yes
Filter	Yes, multimode
Effects	Yes, multi-effects processor
Keyboard	61 keys
Memory	expandable RAM
Storage	Floppy disk drive
MIDI	Yes
Outputs	Stereo
Display	LCD
Timbrality	16-part multitimbral