Kurzweil K2000 User Manual

SECTION 2
K2RVOLTS.OOC 01/05/93
2.19
K2000R VOLTAGE SELECTION
The K2000R is equipped with an internal voltage selector which allows
operation on single-phase AC mains of 100 volts, 120 volts, 220 volts, or 240
volts. The selector is set at the factory for the AC line voltage most
commonly used in the country of destination.
WARNING:
WARNING:
2.19.1
Do not attempt to operate the K2000R on any AC voltaqe other than
the one selected - extensive damaqe to the unit may result!
CHANGING THE VOLTAGE SELECTOR MAY REQUIRE THE USE OF A DIFFERENT
LINE CORD OR ATTACHMENT PLUG, OR BOTH. TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
To Determine the Voltage Setting
Locate the clear plastic cover over the fuse in the power module just below
the AC connector. Look through this cover onto the surface of the Voltage
Selection Card; you will see a three digit number exposed; this number will be
100, 120, 220 or 240 and it indicates the voltage the K2000R is set for.
2.19.2 To Change the Selected Voltage
• Turn the unit off and remove the AC line cord from the AC power connector.
• Locate the Voltage Selector Card which is mounted to the AC entry module
directly beneath the AC connector.
• Slide the clear cover up and over the AC connector. NOTE: This will not
slide up unless the AC cord is removed from the connector.
• Locate the small Voltage Selection card (PC board, approximately 1 1/4" x
3/4") inserted edgewise next to the fuse remover lever. Now locate the
hole used to insert a removal tool (1/8" diameter).
• Using a scribe, small screwdriver or other suitable tool, insert same into
the hole and apply pressure outward (away from the rear of the K2000R); the
Voltage Selection will pull straight out. Take care not to snag the card
on the fuse removal lever.
• Reposition the Voltage Selector Card such that when reinserted the proper
voltage number appears, insert the card, and press fully home.
• If changing from 100V or 120V to 220V or 240V, or vice-versa, replace the
fuses as described under "Fuses" later in this section.
• Close the clear cord and reconnect the AC Cord.
21

Kurzweil K2000 Specifications

General

Type	Digital Synthesizer
Polyphony	24 voices
Weight	35 lbs
Year Released	1991
Waveforms	Sample-based, user loadable
LFO	Yes
Filter	Yes, multimode
Effects	Yes, multi-effects processor
Keyboard	61 keys
Memory	expandable RAM
Storage	Floppy disk drive
MIDI	Yes
Outputs	Stereo
Display	LCD
Timbrality	16-part multitimbral