Kurzweil K2000 - K2000 R Power On Procedure; Switching On the Power

SECTION 2
KRSTART.DOC 01/04/93
2.18.8
Switching On the Power
The power switch is located at the lower left of the front panel. When you
power up, the display will briefly say "Welcome to the K2000R!" The Program
Mode display will then appear. It looks like Figure 2.10 below (the programs
shown in the diagram do not necessarily exist) :
Figure 2.10 - Program Mode Display
Set the volume at a comfortable level. You will get the best signal-to-noise
ratio if you keep the K2000R at full volume (turn the volume knob fully
clockwise), and adjust the level from your mixing board. You may also want to
adjust the display contrast. This is done with the Contrast parameter in
Master mode. See Chapter 11 of the K2000R Musicians Guide. As you trigger
notes from your MIDI controller, you will see the MIDI LED flash. If it does
not flash, check you MIDI cables and connections.
20