Master Mode
The MAST2 Page
11-5
Cables and Connections
Using the K2600 for Both Input and Slave Signals
YouÕll need an insert cable (Y cord) with a 1/4-inch stereo (Tip/Ring/Sleeve) plug (male) on one
end and 2 mono jacks (female) on the other end. The right side mono jack should be 1/4-inch.
The left side can be either 1/4-inch or XLR. (You will be plugging a Mic into the left side, so if
the insert cable has a 1/4-inch jack, youÕll need an adapter from XLR to 1/4-inch.)
1. Plug the stereo side of the insert cable into the 1/4-inch stereo Sample Input.
2. Connect a microphone to the left mono jack of the insert cable. It
must
be the
left
input.
3. Connect the B Right output of the K2600 to the right mono jack of the Insert cable.
Using the K2600 for Input Signal and External Source for Slave Signal
There are two setup methods for this conÞguration. HereÕs the Þrst:
YouÕll need an insert cable (Y cord) with a 1/4-inch stereo (Tip/Ring/Sleeve) plug (male) on one
end and 2 mono jacks (female) on the other end. The right side mono jack should be 1/4-inch.
The left side can be either 1/4-inch or XLR. (You will be plugging a Mic into the left side, so if
the insert cable has a 1/4-inch jack, youÕll need an adapter from XLR to 1/4-inch.)
1. Plug the stereo side of the insert cable into the Stereo Analog Input of the sampler.
2. Connect a microphone to the left mono jack of the insert cable. It
must
be the
left
input.
3. Connect the output of your external sound source to the right mono jack of the insert
cable.
The second method:
1. Connect a microphone into the left low impedance input (XLR) of the sampler.
2. Connect your external sound source to the right low impedance input (XLR) of the
sampler.
Final Audio Output
You must have audio cables connected from the A outputs on the K2600 to your mixer or amp.
DonÕt use the Mix outputs.
MIDI
If you have a keyboard model, and your external slave is a rack (or it is a keyboard but you want
to use the K2600Õs keyboard to control the slave), connect a MIDI cable from the MIDI Out port
of the K2600 to the MIDI In port of the slave.
Setting Up the K2600
1. Go to Sample mode (press the
Sample
soft button in Program, Setup, or Quick Access
mode).
2. Set the Input parameter to a value of
Analog
.
3. Set the value of the Source (Src) parameter to
External
(
Ext
).
4. Set the value of the Mode parameter to
LiveIn
.
To Next Page
Loading...
Need help?
General
