Control Sources
Descriptions of Control Sources
4-3
One control source parameters is always global: the Enable parameter on the LAYER page
(Program Editor). When programming this parameter, youÕll see the Main Control Source list
minus the three special MIDI control sources, minus the following local control sources:
Finally, if youÕve turned on the Globals parameter on the COMMON page in the Program
Editor, the available values for GLFO2, and the values for GASR2Õs trigger will lack the local
control sources listed above, as well as the three special MIDI control sources and the FUN
constants. The available values for GFUN2 and GFUN4 will exclude the same list of local control
sources, but will include the FUN constants.
Descriptions of Control Sources
This section is organized into two sets of descriptions: the MIDI Control Source list, and the rest
of the control sources. The numeral preceding the name of each control source can be entered on
the alphanumeric pad to select the control source directly (press
Enter
after typing the numeral).
Many of the MIDI control sources are assigned as default values for the control assignment
parameters in the Setup Editor. WeÕll indicate these assignments as they appear, simply by
mentioning that theyÕre the default control source for a control assignment parameter.
MIDI Control Source List
With a few exceptions, the MIDI control sources correspond to the standard MIDI controller
numbers used by every MIDI device.
128 OFF
This value eliminates the effect of any control source parameter to which itÕs
assigned.
0, 33 Mono Pressure (MPress)
Many of the K2600Õs factory programs are assigned to modify parameters such as
pitch, Þlter cutoff frequency, and depth control when MPress messages are received.
The mono pressure (Press) control assignment parameters in MIDI and Setup
modes are set by default to transmit MPress messages when mono pressure
messages are received from a controller.
Note St VTRIG2
Key St RandV1
KeyNum RandV2
BKeyNum ASR1
AttVel LFO1
InvAVel FUN1
PPress FUN3
BPPress Loop St
RelVel PB Rate
Bi-AVel AtkSt
VTRIG1 Rel St
To Next Page
Loading...
Need help?
General
