Installing Kurzweil K2661 ROM Options
Installing Object Files
7
8. To install from a hard disk, select the SCSI ID of the disk from which you’re going to
install, then press OK; for SmartMedia, select SMedia then press OK. In either case, the
File Selection page appears.
The K2661 will list all the files in the top level directory on the SmartMedia card or SCSI
device. You can use the alpha wheel, or the up, down, increment (+), or decrement (-) keys
to navigate to the file(s) you want to load. Use the Root, Parent, and Open soft buttons to
move between directories:
Root takes you to the top level directory on the card.
Parent moves you up one directory level.
Open opens the currently selected directory.
The files you’ll need are on the SmartMedia card in a top-level directory called “flash”. On
the CD-ROM, there is a directory called “smedia” that contains the entire contents of the
factory-programmed SmartMedia card. So on the CD-ROM the directory for the files is
/smedia/flash.
These are the files contained in the flash directory:
2661Snnn.KOS K2661 Operating System
K61Vnnn.K26 “Base ROM” objects. Contains ROM1 (Orchestral), ROM2
(Contemporary), and GM objects as well.
OBJKLnnn.K26 “Live mode” objects. Install only if you have sampling option.
OBJEPnnn.K26 ROM4 (Vintage EPs) objects. Install only if you have ROM4.
OBJSDnnn.K26 ROM3 (SD Piano) objects. Install only if you have ROM3.
Highlight a filename, then press the Select button. Press Select a second time to deselect
an item. You can select multiple files from the selection list. The status line at the top of the
screen will show the current directory, how many files are in this directory, and how many
files you have currently selected. An index counter shows you where in the list the cursor
is currently located.
9. Select the base-objects file (K61Vnnn.K26). If you’re installing from a hard disk, you may
need to use the Parent or Root soft button to navigate to the directory where the file is
stored. If you need to select a different drive, press the NewDrv soft button, which returns
you to the Drive Selection page.
After you’ve selected the base-objects file, select the next object file(s) to install (if any).
Use the file list in Table 1 to keep track of the files you’ve installed. Press OK to start the
installation of the selected files.
When the installation is complete, the main Boot Loader page reappears.
10. A hard reset is necessary to reinitialize all objects. Remember that a hard reset will delete
all user RAM (all of the objects that you’ve previously created).
Press the Reset soft button. Press Yes, then press Yes again after it moves to a different soft
button. The operating system will reboot, briefly display “Initializing all memory.”, then
the Program Mode display will appear.
Congratulations! Your option installation is complete
To Next Page
Loading...
