Kurzweil PC88 - Preferred Sounds Configuration

Chapter 1 Basic Operation
Audio Outs
The Left and Right Audio Out jacks are 1/4",
unbalanced for use with a standard instrument amplifier
or mixer. Should you need to connect the PC88 to a hi-fi
system, you will need cables with 1/4" plugs on one end
and RCA (phono) plugs on the other. Use the Left and
Right Audio Out jacks for stereo or just the Left for mono.
The headphone jack carries the same signal as the
main outputs. Plugging it in does not disconnect the
main outputs. Use a standard 1/4" tip/ring/sleeve
configuration.
Front Panel
LCD and Cursor Buttons
The LCD window displays two lines of text and
numbers. Its contrast may be adjusted to accommodate
different playing positions, by turning the small black
rotary knob located on the rear panel between the MIDI
and the Switch Pedal jacks.
Below the LCD are the two cursor buttons, which
enable you to step through the parameters within a
"menu". The cursor buttons also have a "jump" feature.
This is extremely helpful if you need to move through a
very long menu. If you depress both buttons
simultaneously, you can "jump" to a parameter some
distance down the menu.
PC88 Service Manual
1-3