Kurzweil PC88 - Page 41

Chapter 3 Disassembly/Assembly
EMI Shields
Opening the PC88
Prior to opening the PC88, remove power and all
external wires and cables.
There are 9 Phillips head screws that need to be
removed from the rear panel to open the unit. One screw
at each end of the rear panel (where the rear panel meets
the endcaps) and 7 screws along the bottom edge of the
rear panel (where the top cover meets the bottom chassis).
Remove the 9 Phillips head screws on the rear panel.
Refer to the illustration below for the location of the
screws.
There are 5 Phillips head screws used to secure each
endcap. When opening the PC88, it is sometimes easier to
loosen one endcap. The 5 Phillips head screws are located
as follows: 1 at the rear of the chassis (as shown in the
figure below) and 4 on the bottom of the chassis.
Figure 3.3
Remove the 9 Phillips head screws shown from the Rear Panel
Endcap screws
PC88 Service Manual
3-5