Kurzweil PC88 - Page 66

Chapter 3 Disassembly/Assembly
Enclosure Support Wall
Removing the Engine Board
Remove the 8 Phillips head screws that secure the left
hand side of the Enclosure Support Wall.
Remove the 5 Phillips head screws along the rear edge
of the board.
Disconnect the flat ribbon cables and wire cables at the
following locations: J11 (Panel), J15 (Backlite), J12 (Slider),
J13 (Pedals), J9 (MIDI/Footswitch), J7 (LCD), J2 (Audio
Out), and J3 (Power).
The Engine Board can now be removed.
Replacing the Engine Board
Place the Engine Board in position.
Connect the flat ribbon cables and wire cables at the
following locations: J11 (Panel), J15 (Backlite), J12 (Slider),
J13 (Pedals), J9 (MIDI/Footswitch), J7 (LCD), J2 (Audio
Out), and J3 (Power). Be sure to secure the cable
connectors with a locking clips.
Install the 5 Phillips head screws along the rear edge of
the board.
Install the 8 Phillips head screws that secure the left
side of the Enclosure Support Wall.
PC88 Service Manual
3-30