Rear PanelGETTING STARTED GUIDE
9
SW1(SUSTAIN) and SW2 Jacks
Use the SW1 (SUSTAIN) and SW2 jacks to connect switch pedals. One switch pedal is included with the SP7.
In Sound mode, SW1 (SUSTAIN) defaults to controlling Sustain and SW2 defaults to controlling Sostenuto.
Pedal assignments can be adjusted for each zone by using Edit Mode.
1)
2)
Global Mode can be used to set pedal overrides, which can change the pedal assignments for all sounds
globally.
Note: Switch pedals must be plugged in before powering on the SP7.
Do not step on the switch pedals when powering on the SP7, as the state of the pedals is detected as part of the
startup sequence.
· Stream stereo audio between the SP7 and a DAW.
· Use the SP7 as a MIDI controller to play software instruments on your computer/tablet.
· Play and control the SP7 with an external USB MIDI controller.
· Update the engine firmware of SP7.
Use the CC (VOLUME) jack to connect a MIDI CC pedal (also known as a MIDI expression or volume pedal). By
default this pedal is assigned to control the volume (pre-FX).
The optional Kurzweil CC-1 continuous control pedal will work best with the SP7 but it is also possible to use
third-party continuous control pedals designed for keyboards. Compatible pedals should use a 10 kΩ linear
taper potentiometer, with a 1/4 inch tip-ring- sleeve (stereo) plug with the wiper connected to the tip.
CC (Volume) Pedal Jack
The LCD touch screen firmware is updated using an SD card inserted into the SD card slot.
Type : SDHC / Format type : FAT32 / Speed : 4C or more / Capacity : 16GB or more
SD Card Slot
You can connect the SP7 to your computer via USB to perform the following functions:
USB Port
To Next Page
Loading...
