Rear Panel GETTING STARTED GUIDE
2. Rear Panel
Use the AUDIO IN jacks to mix external audio sources with the sounds of the SP7, apply effects to external
audio sources, or route external audio sources to a computer for recording or processing in a DAW. This is
useful for playing along with backing tracks from a portable music player, computer, or other electronic instru-
ments.
Note: If you turn up the volume with nothing connected to the AUDIO INPUT jack on the rear panel, noise may
occur. Turn the volume down to the minimum value when no device is connected.
Audio Input Combo Jacks
Use the HEADPHONE jack located on the left rear panel of the instrument to listen to the SP7 on stereo
headphones. You will need a 1/8-inch-to-1/4-inch adapter in order to use headphones that have a smaller mini
plug connector. When headphones are plugged in, audio is still transmitted from the MAIN OUT jacks.
Headphone Jack
Use the Monitor Out jacks when connecting to an amplifier or speaker for monitoring.
Monitor Out Jacks (stereo)
Use the Main Out jacks to connect to a mixer or amplifier. When performing in mono, use the left jack to connect.
Main Out Jacks (stereo)
Power Switch USB Port MAIN OUT HEADPHONE Jack
AUDIO INPEDALSDC Power Jack
MIDI Port SD Card Slot MONITOR OUT
8
To Next Page
Loading...
