3
Quick StartGETTING STARTED GUIDE
The SP7 starts in Sound mode. To select a different sound, you can use the touch screen or use
the alpha wheel to change the current sound. Narrow selections by pressing the instrument catego-
ry buttons on the right. As you get familiar with the SP7, you can also employ the Favorite mode to
store/recall personal favorites.
You can listen to various demo songs by pressing the Global mode button and then selecting the
Demo Song menu on the left.
The SP7 has an automatic power saving feature (Global mode / Auto Power Off) that can automati-
cally power off the SP7 after a designated period of inactivity, in order to conserve electricity.
Sound Test
1.
2.
Engine firmware update1.
Connect the SP7 and computer with a USB cable (A to B type). The USB port is located on the
rear panel.
While holding down the [DECREASE -] and [INCREASE +] buttons at the same time, turn on the
SP7, wait for about 1 to 2 seconds, then release the [DECREASE -] and [INCREASE +] buttons.
After confirming that the [DECREASE -] and [INCREASE +] button LEDs are lit, run the
SP7Update.exe program on the computer.
Check that [Kurzweil SP (Bootloader)] is displayed in the Device item.
Press the [Start Program] button to start the update.
When the update is complete, a completion message will appear at the bottom of the screen.
Exit the program and reboot the SP7 to complete the installation.
To prevent conflicts with the existing firmware, perform a “Hard Reset” (Global mode / Info
page).
If a problem occurs during firmware installation, try to repeat the installation process above again.
1)
2)
3)
4)
5)
6)
7)
8)
9)
Auto Power On/Off Function
Check out Kurzweil's website (www.kurzweil.com) for new updates. You can check the current
firmware version installed on your SP7 on the Info page of Global Mode.
Firmware update
To Next Page
Loading...
