KHS-6D
CONTROLLER
(cont’dl
16.) Numeric Entry Keys (0
-
9)
-
depending on the mode you are in these keys will allow direct
track access on a CD, an individual station on
n/
or DSS, or a station on a tuner, etc. If you are in
the macro mode, these will allow direct access to your stored macros.
17.) Enter button
-
working in conjunction with the numeric keys above, this button will allow you
to address larger numbers quicker. For instance, if you are looking for track # 23 on a CD, you press
this 2 and then 3 and enter. This will allow access to DSS and multi-disc changers.
The following buttons are completely programmable. They may be reprogrammed to any function
you want depending on the source. In fact, they can be ANY IR related command. It does not even
have to pertain to the source units.
18.) Macro Button
-
this button has it’s own section. Please refer to the
MACRO PROGRAMMING
section in this manual.
19.) Skip Backward
-
this button skips or searches backward. For instance if your source is a CD,
it will skip back to the beginning of the track that is playing, then if pushed again, it will skip back to
next track previous to the one you are on. Repeat as necessary. This is a programmable button. It
may be reprogrammed to any function you want depending on the source.
.
20.) Skip Forward -this
button skips or searches forward. For instance if your source is a CD, it
will skip forward to the beginning of the next track, then if pushed again, it will skip forward to the
next track beyond that one. Repeat as necessary. This is a programmable button. It may be
reprogrammed to any function you want depending on the source.
21.) Power On
-
this button will turn on the source power switch from whatever zone you are in. It
can be programmed to cycle between on and off. When you program this button, press it once and
transmit the code for power on, then press it again for the command to power off. When pressed it
will toggle between on and off positions.
22.) Reverse
-
this button will scan backwards within a track if you are in the CD source mode, or
move down the dial in a tuner source mode. This is a programmable button. It may be reprogrammed
to any function you want depending on the source.
.
23.)
Forward
-
this button will scan forwards within a track if you are in the CD source mode, or
move up the dial in a tuner source mode. This is a programmable button. It may be reprogrammed
to any function you want. Pressing and holding it down will move
it quicker. This is a programmable button. It may be reprogrammed to any function you want depending
on the source.
24.) Play
-
this button in the CD or tape mode will start playing the appropriate device. This is a
programmable button. It may be reprogrammed to any function you want depending on the source.
25.) Pause
-
primarily for tape or CD modes, this button will stop the music and wait in the same
place until the play button (or other function), is engaged. This is a programmable button. It may
be reprogrammed to any function you want depending on the source.
.
26.)
Stop -this
button will stop the CD or tape player in those modes. This is a programmable button.
It may be reprogrammed to any function you want depending on the source.
Page 12
SMARTHOME.COM™ 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com Order #8270C
To Next Page
