Kustom PA40BAT - Battery Life

BATTERY:
IT IS RECOMMENDED THAT THE BATTERY BE RECHARGED AFTER USE TO PROLONG THE BATTERY LIFE.
FREQUENT CHARGING WILL NOT HARM YOUR BATTERY, AND WILL ENSURE THAT THE BATTERY IS FULLY
CHARGED AND READY FOR ITS NEXT USE. STORING BATTERY NOT FULLY CHARGED WILL SHORTEN
BATTERY LIFE.
-Always charge for 12 full hours after heavy use.
-The battery does not need to be fully discharged before recharging.
-It is recommended to stop using the unit under battery power when red Battery Level LED is on.
-For best results, recharge the unit as soon as possible after use.
-It is best if battery is fully charged before storing for long periods of time. Store in a cool, dry place.
40W AC powered with fully charged battery
36W Battery powered
1/8" Headphone/line Level Stereo, mixed mono
Line level 1/4" Un-balanced
Mic XLR Balanced
Line level 1/4" Un-balanced
-56dB Residual Noise, all level controls 0% (minimum)
-52dB Nominal System Noise, all level controls at 50%
+70dB Mic to Speaker Output (CH 1 & 2)
+50dB Line to Speaker Output (CH 1 & 2)
+40dB AUX IN to Speaker Output
Channel EQ (high, low)
Phantom Power
+9V Mic Input
USA/Canada 120VAC/60Hz, 80W nominal
Europe/UK/Australia 230~240VAC/50Hz, 80W nominal
China 220VAC/50Hz, 80W Nominal
Speakers Two 4½" 50W 4 Ohm each
Horn
Power Capacity
40W RMS total system
Frequency Response system 70HZ-20kHz
92dB 1W-1M nominal
Nominal Impedance 2x4 Ohms Not designed for external speakers
mm/kg 180 (width), 525 (height), 190 (depth), 9.6 kg
Inches/Pounds 7 (width), 20 ¾ (height), 7½ (depth), 21¼ lb
Output Power
Hum & Noise
Dimensions & Weight
Bluetooth Module Features.
(Available on PA40BATBT only)
20HZ-20kHz
Actual response is tailored to speaker cabinet for
accurate acoustical response.
Bluetooth 3.0+ERD compliant. Typical +2dBm Class 2 power.
Audio DAC: 94dB SNR.A2DP profile support
Accepted Inputs
One 3½" piezo driver
CH 1
CH 2
PA40BAT & PA40BATBT Powered PA Specifications
4kHz and above , 800Hz and below.
Power Requirements
Sync (IN and OUT) System
Linking Circuit
Both jacks accept a balanced input and send a pre-master volume output mix of
channels. Recommended use: Linking two PA40BAT(BT) together.
System Gain
(Measurements made at 1kHz)
Frequency Response