Kuvings B6000 - Page 2

How to Assemble
1.
Firmly insert the compression
silicone into the slot below
the pulp spout.
3.
Place the juicing screw into the
strainer. Turn and press down
on it until it clicks into place.
4.
Aligning the red dot
●
on
the drum lid with the red dot
●
on the juicing bowl. Turn
clockwise to close, aligning
the red dot
●
on the drum
lid with the close mark
.
2.
Assemble the strainer into
the rotation wiper. Place this
assembly in to the juicing
bowl ensuring the red dot
●
on the strainer is aligned with
the red dot
●
on the juicing bowl.
The Juicer may leak if not
assembled properly.
The juicing screw needs to be
locked in place in order to close
the drum lid.
5.
6.
Place the drum lid on the juicing
bowl. Align the down arrow
▼
on the drum lid with the
OPEN mark on the base and
turn to the CLOSE position.
7.
Place the pulp cup under the
pulp spout and place the juice
cup under the juice spout.
Juicer will not operate if parts are
not assembled properly.
Silicone Ring
Silicone Brush
Push in the silicone ring with the
smaller surface facing down.
Tail
Insert into the slot with the tail
pointing down.
●
●
Detachable
!
!
!
Open/Close mark on the top-
set.
Open
Close