Need help?Do you have a question about the Kverneland EDW2 and is the answer not in the manual?
Details on setting up ISO spreaders with non-ISO and ISO tractors.
Overview of IsoMatch Tellus GO, Tellus and Tellus PRO controlbox configurations.
Information on the IsoMatch Power supply and its components.
Details and wiring diagram for the battery cable connection.
Specification and pin assignment of the IM Tellus connection cable.
Technical details and pinout of the ISOBUS connector.
Description of communication and power cables for the machine side.
Description of the EDW2 PCB, including new generation connectors and status LEDs.
Information on the TrimFlow sensor, its BSI box, and connection.
Details on the inductive sensor for measuring disc RPM and testing procedures.
Explanation of the reference sensor, its function, and testing methods.
Description of load cells, their function, connection, and checking procedures.
Information on actuators, their function, testing, measurement, and repair.
Overview of the machine software, including version and main interface.
Description of the spreader's main screen and its various data displays.
Details on Curve Calibration, Settings, Trimflow, and Field Registration screens.
Accessing service settings and calibration through PIN codes.
Configuration of Virtual Terminal, TC, and GEOCONTROL settings.
Accessing diagnostic screens for software version, system info, and sensor values.
Procedure for calibrating the machine's actuators for optimal performance.
Steps for hopper calibration using Pincode 5, including empty weight setup.
Calibration procedure using Pincode 8 for specific hopper types (Except CL EW/RO-M EW).
Specific calibration steps for RO-M EW/CL-EW models using Pincode 8.
Process for calibrating the speed sensor to ensure accurate speed input.
Verifying calibration results by checking stored values in diagnostic screens.
Instructions for using manual border spreading plates with GEOCONTROL.
Instructions for using hydraulic border spreading plates with GEOCONTROL.
Setting up TC configuration, license, and implement parameters for GEOCONTROL.
Methods for calculating and setting the 'B' distance for GEOCONTROL.
Explanation of common alarms, errors, and their potential causes.
Flowcharts for diagnosing and resolving weighing system and actuator issues.
How to adjust the electrical hopper cover and its PCB/software connections.
Warnings for empty hoppers and identification of system components.
Configuration and diagnostic checks for the empty hopper sensor system.
General| Brand | Kverneland |
|---|---|
| Model | EDW2 |
| Category | Spreader |
| Language | English |
To Next Page
