1.1 ISO spreader with a Non-ISO Tractor
Setup for an ISO spreader and a Non-ISO tractor
The IsoMatch Tellus and IsoMatch Power Cable is conferting a non Iso
tractor into a Iso tractor.
This IsoMatch Power Cable supplies electrical power to spreader and
Control box (speed source is needed)
See also chapter 1.4
All weighing spreaders are standard ISOBUS machines. Depending on the configuration the machine can have several components
1.2 ISO spreader with IM Tellus, Tellus GO or PRO
Setup for an ISO spreader and a ISO tractor
The IsoMatch Tellus can be used on an ISO-Bus tractor. There for you need to
connect the tractor canbus to the IM Tellus. Normally you can use the 9 pin
INCAB connector cable available in the store (IsoBus standard).
See also chapter 1.4
4
1. System overview
To Next Page
