TYPE 9101 07/2014 10
Outer surfaces cleaning
Clean the appliance after cooling.
• Enamelled surfaces should be cleaned with a damp cloth or sponge, and then polished to
dryness. Never use abrasives which could affect the enamel surface. With higher pollution
you can use detergents.
• It is important to protect the hob from water to avoid corrosion. Clean it only when it is dry. If
you use a damp cloth with detergent when cleaning the hob, the hob should be dried when
finished. From time to time we recommend greasing the hob with a thin layer of vegetable fat.
The appliance cannot be lit: - inspect the flue ways, flue gas duct and chimney
- check the, air rose, fire place door and ash tray
Overheated appliance - put out of service, do not stoke, close the air rose, let fire burn
out
Fire in the chimney - do not use water to extinguish the fire
- close all of the air intakes, cover the chimney if possible
- contact a qualified chimney sweep service to evaluate the
chimney condition after the fire
- contact your supplier.
Do not carry out repairs by yourself if faults occur during the guarantee period. File a claim in the
shop where the product was bought or in a guarantee repair shop and support it with a duly
completed guarantee card. Guarantee claim requests can be set up only in cases where all
guarantee conditions are met.
Corrugated board, packing paper - recycle
Wooden parts - recycle or re-use
PVC strips, sacks, foils - recycle if available, or dispose of sensibly
The appliance contains valuable materials that can be recycled. Your Local Authority or a licensed
scrap firm can organise this for you.
To Next Page
Loading...