KWIK GOAL FLEX User Manual

NZ423 Rev. 02/11/19
140 Pacific Drive Quakertown, PA 18951
(P) 215-536-2200 / (P) 800-531-4252 / (F) 215-536-4309 / (F) 800-778-8869
Visit our website @ kwikgoal.com
©2017, Rev. 2019 Kwik Goal Ltd.
Parts
ASSEMBLY INSTRUCTIONS FOR 2P1901 KWIK FLEX FUTSAL GOAL
1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred,
notify Kwik Goal immediately. Lay out all parts. Remove all cardboard and packaging immediately. Wet or
damp packaging may damage contents.
Net (1)
(Part# VZ813)
Left Base (1)
(Part# VZ725)
Right Base (1)
(Part# VZ726)
Left Rear Base (1)
(Part# VZ814)
Left Center Base (1)
(Part# VZ816)
Right Rear Base (1)
(Part# VZ815)
Center Connector (1)
(Part# VZ734)
Right Center Base (1)
(Part# VZ817)
Carry Bag (1)
(Part# VZ818)
Rear Tension Rod (2)
(Part# VZ858-03)
36-5/8”
Front Tension Rod (2)
(Part# VZ858-05)
42-1/2”
Bottom Tension Rod (4)
(Part# VZ859-03)
45”
“J” Anchor (4)
(Part# VZ786)
®

KWIK GOAL FLEX Specifications

General

Brand	KWIK GOAL
Model	FLEX
Category	Sports & Outdoors
Language	English

Summary

Parts Identification

Assembly Steps

Open Base Frame

Open the base frame by swinging outward until button locks engage in the center connector.

Connect Rear Bases

Pull left and right rear bases until button locks into place on center bases. Do not force parts.

Open Front Bases

Open left and right bases by swinging outward until button locks engage in the left and right rear base.

Add Tension Rods

Attach tension rods (front and rear) to the base structure as shown in the diagrams.

Connect Net to Front Rods

Connect top corners of the net to the front tension rod assembly by sliding rod cap over the rod end.

Connect Net to Rear Rods

Connect backdrop corners of the net to the back tension rod assembly by sliding rod cap over the rod end.

Secure Net to Bases

Secure the net corners to the left and right bases using hook and loop straps.