KYMCO Dink 50 - Water Pump Shaft Removal

12. COOLING SYSTEM
12-14
DINK50/ 125
WATER PUMP SHAFT REMOVAL
Disconnect the water hose from the right
crankcase cover.
Remove the 3 bolts attaching the water
pump assembly.
Remove the water pump assembly, gasket
and dowel pins.
Remove the water pump bearing snap ring
from the water pump assembly.
Remove the water pump shaft and shaft
inner bearing.
Remove the water pump shaft outer
bearing.
Inner Bearing
Snap Ring
Water Pump Assembly
Bolts
Inner Bearing
Water Pump Assembly
Water Pump Shaf
t
Water Pump Shaf
t