Tires
TIRE
SIZES
The ATV is equipped with low-pressure tubeless tires
of
the size and type listed (see Section 1).
Do
not
under
any circumstances substitute tires
of
a different type or
stze.
Always use the size and type of tires specified.
Always maintain proper tire inflation pressure.
TIRE
INFLATION
PRESSURE
Front a
nd
rear tire inflation pressure should be 0
.28
kg-cm
2
(
4.0 psi).
Steering
Components
The following steering components sh
ou
ld
be
in
spected
periodically to ensure safe and proper operation.
A. Handlebar grips not worn, broken, or
lo
ose.
B. Handlebar not bent, c
ra
cked, and
ha
s equal and
complete full-left and full-ri
ght
capabili
ty.
C. Steering post bearing assembly/bearing housing
not
broken,
wo
rn
, or binding.
D. Ball joints
not
worn, cracked,
or
damage
d.
E. Tie rods n
ot
bent or cracked.
F.
Knuckles not wo
rn
, cracked, or damage
d.
G Cotter p
in
s
not
da
ma
ged or missing.
Driveshaft/Coupling
The following drive system components sh
ou
ld be
inspected periodically to ensure
proper
operation.
A. Spline lateral movement (slop).
B.
Coupling cracked, dama
ge
d, or worn.
2-12
Suspension/:Shock
Absorbers/Bushings
The foll
ow
in
g suspension system components sho
uld
be
in
spected periodically
to
ensure proper operation.
A. Shock absorber rods not be
nt
, pitted, or damaged.
B.
Rubber damper not cracked, broken, or miss
in
g.
C. Shock absorber body
not
damaged, punctured,
or
leaking.
D.
Shock absorber eyelets
not
broken, be
nt
, or
c
ra
cked.
E. Shock absorber eyelet bushings
not
worn
, dete-
riorated, cracked, or
mi
ss
in
g.
F.
Shock absorber spring
not
broken or sagging.
Nuts/Bolts/Cal=•
Screvvs
Tighten all
nut
s, bolt
s,
and cap screws. Make
su
re riv-
ets holding components together are tight. Replace all
loose rivets. Care
must
be taken that all calibrated
nuts, bolts, a
nd
cap screws are tightened to specifica-
tions.
To Next Page
