3.
Check all control cables for signs of wear or
fraying.
Replace if necessary.
4.
Change the engine/transmission oil and filter.
5.
Charge the battery; then install. Connect
the battery
cables.
CAUTION
The
ignition
switch
must
be in the OFF
position
prior
to
installing
the
battery
or
damage
may
occur
to
the
ignition
system.
CAUTION
Connect
the
positive
battery
cable
first,
then
the
negative.
6.Check the entire brake systems (fluid
le
vel,
pads, etc.), all controls, lights, and
headlight aim; adjust
or
replace as
necessary.
?.Tighten
all nuts, bolts, cap screws, and
screws making sure
all calibrated nuts, cap
screws, and
bolts are tightened to
specifications.
8.Check tire pressure,
Inflate to recommended
pressure as necessary.
9.Make sure the steering moves
freely and
does not bind.
1 O.Check the spark plug. Clean
or
replace as
necessary.
1-7
To Next Page
Loading...
