*2: The printer can be set to print error data during KPDL emulation. If this is set toý2Q, error data will be printed if trouble occurs during printing.
This is set toý2II before leaving the factory. *3: You can select either Courier or Letter Gothic. Any font can be selected asý'DUN orý5HJXODU. These fonts
are displayed when the Font menu is Internal. *4: Theý!6L]H menu is not available for the Courier and Letter-Gothic fonts. Theý!3LWFK menu is displayed
instead for these fixed width fonts. *5: Althoughý$XWR is the default setting and this menu does not usually appear, page protection mode will be forcibly set
to on if aý3ULQWýRYHUUXQý3UHVVý&217,18( error occurs due to insufficient printer memory. Be sure to return this setting toý $XWR in order to
maintain high printer memory efficiency. *6: Turning this toý21 increases the maximum number of characters that can be printed in a line for an A4 page (78
characters at 10 pitch) and likewise increases the maximum per line on Letter size paper (80 characters at 10 pitch).(Only PCL 6 emulation) *7: This sets the
resolution for printing.
For 1200 dpi there are two modes. In Fast 1200 mode, printing is equal to 1200 dpi (1200 dpi horizontal × 600 dpi vertical) comparatively, Fine 1200 mode
is slower, but in Fine 1200 mode true1200 dpi printing is facilitated. The printing is slower than Fast mode but the print quality is better. *8: This is displayed
only after the FS-1750 memory has been expanded. (The total must be 12 MB or more) *9: This is displayed when the size dial on the paper cassette is set to
Custom. (See section 2.7. Setting Custom Sizes.) *10:This sets whether to enable or disable the difference between A4 size and letter size. Under the default
setting ofý 2II, the paper size of the paper source is matched to the paper size given for the data, and if these differ a corresponding error message is
displayed.
When this is set toý2Q, printing is performed even if the actual paper size differs from the paper size given for the data. *11:This menu is displayed only
whený&XVWRPýú is selected. *12:After the printer accepts all data and there is no more data from the computer, the printer will wait a set amount of time
without printing the final page. Once this preset amount of time has elapsed, the printer will automatically issue a form feed. This timeout setting can be set in
5-second increments up to 495 seconds.
*13:This is the total number of pages printed by the printer up to the present time. *14:These menus are for service personnel. They should not be operated by
the user..
You're reading an excerpt. Click here to read official KYOCERA
FS-1750 user guide
http://somemanuals.com/dref/324820
Powered by TCPDF (www.tcpdf.org)
To Previous Page
Loading...
