Kyocera FS-720 - Connecting to Power

Connections
10 OPERATION GUIDE
Connecting to Power
Install the printer close to an AC wall outlet. If an extension cord is used,
the total length of the power cord plus extension should be 5 meters (16
feet) or less.
NOTE: Ensure the printer’s power switch is off. Only use the power cord
supplied with the printer.
1
Connect the power cord to the
Power Cord Connector at the rear
of the printer.
2
Connect the other end of the power cord to a power outlet.
3
Press the Power Switch to On
( | ).
The printer begins to warm up.
IMPORTANT: If you install the Toner Container and switch on the power,
the two indicators will start fast flashing. When the printer is first switched
on after toner installation, there will be a delay of approximately 15 minutes
before the printer gets ready to print. Once the Ready indicator lights,
printer installation is complete.