Kyosho Presto User Manual

[J SMALL PARTS USED
M3X 10
CAP SCREW (2)
IOD . 111111! ,l llm w IIIII J
M3X 16
CAPSCREW (1)
@
3,0WASHER
Adj ust the mesh ing of the gears so that
they move freely but still maintain good
contact. "Backlash" is the amount of
ply in the gear mesh. You should have a
small
amount of backlash.
: ,1V SPUR GEAR
r@ CLUTCH BELL (12T)
Barely loosen 3 motor bolts to make
your backlash adjustments retighten
when adjustments are complete.
~ SMALL PARTS USED
~ @ CHAII\J JOINT (1)
r;JJ ®CHAIN WASHER (1)
# I® CHAIN CLIP (1)
~ SMALL PARTS USED
@
M4 NUT (2)
~ ENGINE
M3 X 10 CAP
SCREWS
~ CHAIN
I nstall the strap as shown to
the bulkhead plate. This pre-
vents
the chain from derailing.
FRONT
01 FFERENTIAL
To dissassemble the chain,
remove the chain joint and
clip.
~ BUIVIPER
MOTOR ASSEMBL Y
@ TENSIONER SHAFT
DIFFERENTIAL
Adjust the tensioner shaft so
that the chain has about
3mm of play or slack.
I

Kyosho Presto Specifications

General

Brand	Kyosho
Model	Presto
Category	Motorized Toy Car
Language	English