Kyosho Presto User Manual

m SMALL PARTS USED
M3 ,X 8 SELF
TAPPING SCREW
(8)
M3 X 5 SCREW (8)
3,0WASHER (8)
o @ COLLAR (2)
Place the four wheel shaft bearings onto
the four wheel shafts as shown ,
WHEEL SHAFT
" BEARING A
~ "WHEEL SHAFT
mJ SMALL PARTS USED
M3 X 12
CAP SCREW (2)
(0)
® TENSIONER
10: E RING (1)
GUIDE (1)
( E -4)
After completing the assembly shown at
right , install the tensioner guide and
E-Ring onto the tensioner shaft ,
~ SWING SHAFTS
@ REAR SWING I~_ _ -
~Q
N'OTE ' Th. ~.: ~;" ...... , ".
thicker than the front swing
shafts.
@ WHEEL
SHAFT
@ WHEEL SHAFT BEARING
FRONT
NOTE : Remember that the front swing
shafts are thinner than the rear swing
shafts.
@
FRONT SWING SHAFT
NOTE: Fit the collar into the joint first.
Then I nstall the swing shaft.
m SPUR GEAR MOUNT
IIi:.I
6)fWASHERS
M3 X 30SCREW
NOTE : If
you are using the OS Max .21 place thd
circle mark on the outside as shown. For I rvine or
Enya , the circle mark should be placed on the inside.

Kyosho Presto Specifications

General

Brand	Kyosho
Model	Presto
Category	Motorized Toy Car
Language	English