9
■
Preparations
●
Battery Installation
● Battery Level Warning
Battery Box
1.
2.
3.
R03/AAA/UM4
Batteries (4pcs.)
Press the tab on the bottom of the transmitter to open
battery box cover.
Remove the lock to pull out battery
box.
Install four R03/AAA/UM4 alkaline
batteries while noting their polarity,
then replace
battery box.
Use batteries which have adequate remaining capacity. Weak
batteries mean lower transmitting power and may result in
malfunctions.
Do not install Ni-Cd or Ni-MH batteries in the battery box.
(These may cause the battery connectors to corrode.)
If the Xpansion unit is not assembled or
used, do not use the LiFe/LiPo battery.
To Next Page
Loading...
