Need help?Do you have a question about the L-Acoustics WST K2 and is the answer not in the manual?
General| Brand | L-Acoustics |
|---|---|
| Model | WST K2 |
| Category | Enclosure |
| Language | English |
Emphasizes protective gear and prohibits climbing on assemblies.
Stresses verifying WLL for third-party rigging accessories.
Advises respecting manual limits and using SOUNDVISION for conformity checks.
Warns about checking personnel and securing elements during flight.
Advises checking stability and using safety straps for ground stacks.
Lists and briefly describes essential rigging components like K2-BUMP, K2-BAR, K2-LINK.
Details safe and maximum limits for ground-stacked and flown arrays.
Explains how to assess safety, the inadequacy of WLL alone, and using SOUNDVISION.
Describes K2 enclosure rigging arms (front rotating, rear sliding) and locking system.
Explains the K2-BUMP for flying arrays and the K2-BAR for extending site angle range.
Outlines the process for flying K2 enclosures under a K2-BUMP.
Step-by-step guide for stacking K2 enclosures onto a K2-BUMP.
Detailed steps for attaching a block of four K2 under a K2-BUMP.
Steps for attaching a block of four K2 enclosures under a flown K2 array.
Guide for attaching a block of four K2 under a KI or KI-SB system element.
Instructions for attaching KI or KI-SB enclosures under a K2-BUMP.
To Next Page
