L3 Communications MPM-1000A - Page 8

MPM-1000A Operator Manual 1000-7075 Rev E
viii
Figure 6-8 Edit Bandwidth Segment Dialog using Transfer Gain ................................. 6-8
Figure 6-9 Edit Bandwidth Segment Dialog using Saturated Flux Density ................... 6-9
Figure 6-10 Modem Stack .......................................................................................... 6-11
Figure 6-11 Configure File Menu ................................................................................ 6-12
Figure 6-12 Select Mode Screen ................................................................................ 6-12
Figure 6-13 Configure Drop Down Menu .................................................................... 6-13
Figure 6-14 IP Address Configuration Screen ............................................................ 6-14
Figure 6-15 Change HCI to Modem Address ............................................................. 6-14
Figure 6-16 Configure Modem Screen ....................................................................... 6-15
Figure 6-17 Configure Drop Down Menu .................................................................... 6-16
Figure 6-18 Multi-Modem Configuration Screen ......................................................... 6-16
Figure 6-19 Configure Slave Modem.......................................................................... 6-17
Figure 6-20 Multi-Modem Configuration ..................................................................... 6-17
Figure 6-21 Configure Slave Modem.......................................................................... 6-18
Figure 6-22 Slave Status after Changing Mode ......................................................... 6-18
Figure 6-23 Wait for Secure Link Status ..................................................................... 6-19
Figure 6-24 Multi-Modem Status Screen .................................................................... 6-19
Figure 6-25 Figure Configure Menu ........................................................................... 6-21
Figure 6-26 TERM CAL ON Status box ...................................................................... 6-22
Figure 6-27 Terminal Calibration Screen .................................................................... 6-22
Figure 6-28 Calibration File Screen ............................................................................ 6-23
Figure 6-29 File Validation Success ........................................................................... 6-23
Figure 6-30 Losses Screen ........................................................................................ 6-24
Figure 6-31 Terminal Losses File Screen ................................................................... 6-25
Figure 6-32 File Validation Successful ....................................................................... 6-25
Figure 6-33 Configure Menu ...................................................................................... 6-25
Figure 6-34 Terminal Gains File Screen ..................................................................... 6-26
Figure 6-35 Manual Entry Screen............................................................................... 6-27
Figure 6-36 Losses Screen ........................................................................................ 6-28
Figure 6-37 Configure Menu ...................................................................................... 6-29
Figure 6-38 Nominal Entry ......................................................................................... 6-29
Figure 6-39 Losses Screen ........................................................................................ 6-30
Figure 6-40 Disable Terminal Calibration ................................................................... 6-31
Figure 6-41 Terminal Calibration OFF ........................................................................ 6-31
Figure 7-1 Typical System Setup ................................................................................. 7-1
Figure 7-2 TRANSEC Screen ...................................................................................... 7-2
Figure 7-3 TRANSEC Screen ...................................................................................... 7-4
Figure 7-4 New Current MSK Entry Screen ................................................................. 7-4
Figure 7-5 MSK Entry Status Screen ........................................................................... 7-5
Figure 7-6 TRANSEC Pass Phrase Selection Screen .................................................. 7-5
Figure 7-7 Pass Phrase Entry Screen .......................................................................... 7-6
Figure 7-8 PuTTY Security Alert Window ..................................................................... 7-6
Figure 7-9 Status Screen for Secure Link .................................................................... 7-7
Figure 8-1 Basic Network Architecture ......................................................................... 8-2
Figure 8-2 MF-TDMA Structure .................................................................................... 8-4
Figure 8-3 Configure Menu Tab ................................................................................... 8-9