www.lacrossetechnology.com/support Page | 1
Model: 404-1220
Instruction Manual
DC: 050614
20 “ Atomic Wall Clock
Get Started
Step 1: Insert 1 fresh “C”, LR14 1.5 volt ALKALINE battery
according to the polarity marked on the case.
Step 2: Firmly press the time zone button once.
Step 3: Position the clock on an exterior wall that faces Ft.
Collins, Colorado. During the night, your clock will
automatically set itself.
Note: The hands will move to the 12:00, 4:00 or 8:00
position and search for the radio signal. If the radio
signal is received the time will set. If the signal is not
received the clock will stay at the 12:00, 4:00 or 8:00
position and search for the WWVB time signal on the
even hours. Once the radio signal is decoded, the hands
will automatically adjust to the correct time. This may
take up to 5 nights.
Step 4: The default time zone is Pacific Time. If the clocks sets
itself and the hours are off, hold the correct time zone
button for 5 seconds to correct.
Position Clock
Choose a location 6 feet or more from electronics such as
cordless phones, wireless gaming systems, televisions,
To Next Page
Need help?
General
