La Crosse Technology EH-23SA E Howard - Atomic Signal and Hand Alignment; Manual Search for Atomic Time Signal; Realign the Hands; Specifications and Support

3
E HOWARD ATOMIC WATCH
Manual Search for Atomic Time Signal
Realign the Hands
Specifications
1. Hold the
PUSH-PIECE
for about 4 seconds. The hands will advance to the 12:00 position. “
SET
” and
“
12
” will then flash alternately in the LCD.
2. Place the watch on a steady surface for better reception. Prior to WWVB reception (and 15 seconds
after holding the
PUSH-PIECE
) the hands will automatically return to the manually set time.
3. The watch is now set to the WWVB atomic signal reception mode. If the reception is disturbed
(ex: close proximity to metallic objects or electric appliances), the watch will automatically try
several times to receive the WWVB signal.
If the time is displayed incorrectly despite successful WWVB signal reception, the hands will need to be
adjusted manually.
1. Hold the PUSH-PIECE for about 5-10 seconds until the hands begin to spin. Release the button.
2. If the hands do not line up exactly at 12:00 the LCD display will read “SET 12”.
3. Hold the RECESSED BUTTON to set hands to 12:00. As you approach 12:00, press and release the
RECESSED button to avoid going past 12:00.
4. When you have reached 12:00 release the watch sit for 15 seconds. The hands will spin and should
stop at the correct time for the selected time zone.
This watch will withstand splashes of water or rain but should
not
be worn while swimming or
diving.
Operating temperature:
32 - +122°F
Battery type:
3V CR2025 Lithium
Quartz accuracy:
+/- 1 second per day
Battery life:
about 2 years
(Low battery indication will appear when low power is detected)
Water Resistance