espresso coffee machines
30
LSI 089 - Rev. 00 - Ed. 04/2015
DIFFERENT TEMPERATURE RANGE
To program a different range of temperature (from 65°C to 85°C), proceed as follows:
1. Switch off the appliance
2. Press and hold down together the buttons (g) and (i), on the programming touchpad and switch on the appliance using the main
switch (12).
3. Only the previously set value for the temperature will remain lit on the control panel.
4. Press and hold press for 10 seconds the button
(h), the light of the previously set value blinking.
5. To change the setting, press the buttons (g) and (i).
6. To quit the programming function and store the new setting, switch the appliance off and then on again, using the main switch (12).
After setting the temperature, it is necessary to set the air suction using the milk
foamer regulator behind the front panel, close to the steam wand with the steam
wand with temperature probe (Fig. 13).
Turn the adjustment screw anticlockwise to increase milk foaming.
Turn the adjustment screw anticlockwise to reduce milk foaming.
An approximate calibration is carried out during the test testing phase, loosening the
adjustment screw by one and a half turns.
Take note!
The temperature value on the control panel must be converted back using the conversion table here below:
°C
t
65
66
67
68
69
70
71
72
73
74
75 76
77
78
79
80
81
82 83
84
85
105
106
107
108
109
110
111
112
113 114
115 116
117
118
119
120
121
122
123
124 125
Danger!
When adjusting the milk foaming level, take care not to touch the steam wand
with temperature probe or wear protective, to prevent possible burns.
Fig. 13
AIR REGULATOR
To Next Page
Loading...
