LABEL-AIRE Write-up 3138NV-DAT - SIDE AND REAR CONFIGURATION

To Next Page

To Previous Page

23



20.Repeatstep#14.Starttheconveyorandwatchasthesidetampappliesthelabel.

21.Ifthelabelwasappliedearly,increasetheSECONDLABELPOSITION.Ifthelabelwasappliedlate,

decreasetheSECONDLABELPOSITION.

Repeatuntilthelabelisappliedcorrectposition.

NOTE: If

theSECONDLABELPOSITIONsettingisinsufficienttoallowtimeforthesecondlabeltobe

printed.Thesecondlabelwill not beappliedandLABELPOS.ERRORwillbedisplayed.Insuchacases,

youcanincreasetheSECONDLABELPOSITIONsetting,decreasethelinespeedordecreasethemachine



cycletime.

22.Afterbothlabelsareappliedcorrectly,disablethetamp. 

SIDEANDREARCONFIGURATION

1. Pressthe[CUSTOM]buttontillthetampdisableappearsonthemenuscreen.

2. Entertheadvancedmenu.

3. Positiontheleadedgeofaproductatproductdetector#1(stopconveyor).Seefigure10.

4. Manuallyapplyalabeltotherequiredpositiononthesideoftheproduct.

5.Refertofigure10.Measurethedistancebetweentheupstreamedgeofthetamppadtothe

upstreamedgeofthelabelonthesideoftheproduct.Thisistheapproximatedistancethattheproduct



willtravelduringtheLABELONPRODUCTPOSITIONtime.Recordthedistance"A".

6.Iftheconveyorisrunningat45feetperminute,theconveyorisrunningatapproximately9inchesper

second.Iftheconveyorisrunningat15metersperminute,theconveyorisrunningatapproximately

0.25meterspersecond.

NOTE: Iftheconveyorisrunningatsomedifferentspeed,determinehowfartheconveyortravelsin

onesecond.

