Need help?Do you have a question about the Lackmond BEAST10 and is the answer not in the manual?
Explains symbols used to indicate potential dangers and the importance of heeding them.
Provides information and instructions intended to prevent equipment or property damage.
Guidelines for maintaining a clean, well-lit, and safe work environment to prevent accidents.
Crucial precautions to prevent electric shock, including grounding and cord safety.
Rules for selecting and using extension cords safely with the power tool.
Detailed steps for proper grounding to reduce the risk of electrical shock.
Recommendations for operator safety, including apparel, awareness, and avoiding distractions.
Covers safe practices for tool usage, maintenance, and storage to prevent injury.
Guidelines for maintenance and repair, emphasizing using identical parts and qualified personnel.
Critical warnings and instructions for safe operation of the wet tile saw.
Warnings about dust inhalation and skin contact with hazardous chemicals during operation.
Information on chemicals known to cause cancer or reproductive harm in California.
Lists all components included in the saw package for verification upon receipt.
Instructions for properly installing the water tray into the saw frame.
Steps for mounting the saw arm assembly to the main frame using screws.
Guide for correctly attaching the worktable to the saw rails and locking it.
Instructions for fitting the lower and upper splash trays securely onto the saw.
Steps to attach the table extension to the worktable for increased surface area.
How to install and secure the miter guide for making angled cuts.
Importance of water for blade cooling and ensuring proper operation.
Detailed steps for setting up the water tray and pump for blade lubrication.
Alternative method to supply water using a bucket and the submersible pump.
Procedure for emptying water from the tray after use to prevent issues.
How to start and stop the saw motor using the main power switch.
Securing the saw when not in use with a padlock to prevent unauthorized operation.
Procedure to reset the internal breaker after power interruption or if it trips.
General warnings and guidance for performing various types of cuts with the saw.
How to set up and perform a straight cut using the miter guide.
Instructions for making cuts at various angles using the miter guide.
Steps for making beveled cuts at specific angles like 45 and 22.5 degrees.
How to perform plunge cuts by lowering the blade into the material.
Method for setting the cutting depth for different material thicknesses.
Detailed procedure for safely replacing the cutting blade using provided tools.
How to verify and adjust the saw's bevel angle accuracy using a square.
Instructions for cleaning the submersible pump to ensure optimal performance.
Steps for detaching and reattaching the water nozzle for cleaning or replacement.
Procedure for aligning the cutting wheel perpendicular to the worktable for accurate cuts.
Solutions for motor overheating or failure to run, including checking connections.
Troubleshooting steps for the water pump not delivering water to the table.
How to address issues with the worktable sliding smoothly, including cleaning rails.
To Next Page
General
