12V 1.5A
MAC
SERIAL
Network Key (Password):
XXXXXXXXXXXX
XXXXXXXXXXXX
XXXXXXXXXXXX
WiFi Network Name (SSID):
Orbi Router RBR20
NETGEAR
ORBI LOGIN
Network Name:
Laerdalnet1234
(last four digits
in MAC address)
12V 1.5A
MAC
SERIAL
Network Key (Password):
XXXXXXXXXXXX
XXXXXXXXXXXX
XXXXXXXXXXXX
WiFi Network Name (SSID):
Orbi Router RBR20
NETGEAR
ORBI LOGIN
Network Name:
Laerdalnet1234
(last four digits
in MAC address)
5 6
4
7 8
1 2 3
First Time WiFi Setup for Simulator Router and SimPad PLUS
Connect SimPad and
Simulator with cable
Turn on SimulatorPlug in and turn on router Turn on SimPad PLUS
Steady green light
= ready
Steady pink light
= ready
Select Simulator Select WiFi network
Press and select
connected simulator.
Follow on-screen
instructions.
Look under the router to find the name
of the network and the password.
Press and select
WiFi network.
Enter Network Name and password Connect to PC with Patient Monitor (Optional)
If you experience connection problems, repeat this process.
Important: Do not reset the router. This might require customer service from Laerdal.
Turn on PC and open Laerdal Simulation Home, then
open “Network Selector“. Select same WiFi network and
follow on-screen instructions.
When the network is established, you can disconnect the network cable.
www.laerdal.com
© 2020 Laerdal Medical AS. All rights reserved.
Tanke Svilandsgate 30, 4002 Stavanger, Norway
T: (+47) 51 51 17 00
Printed in Norway
The recommended simulator setup for this router is: one simulator, one SimPad Plus and one PC with Patient Monitor (Optional).
Please follow this process in the right order to ensure an optimal connection.
Intended Use
If you need a more advanced setup with more simulators, contact your local IT support. Alternatively, contact Laerdal for further help.
How-to-video
www.laerdal.com/simulator-router
For an easy step by step video of this process
and language versions, go to:
To Next Page
Need help?
General
