LAGOON 421
5
FITTINGS
45
v
- Take advantage of the fine weather to take the settee and berth
cushions out.
- Put the cushions vertically if you leave the boat for long.
- Use blinds to protect the inside of the boat against UV rays.
- Make sure the bilges are clean and dry.
• INSIDE VARNISH
- Rinse the inside varnish with fresh water mixed with spot remover
and shampoo.
- Polish the inside varnish with shammy leather.
ADVICE: Mark up each cover and foam when dismantling.
•STAIN REMOVAL
- Remove as much stain as you can with a knife blade (from the
edge towards the centre).
- Dab with a clean rag.
- Remove the stain with solvent on a clean rag. Never pour the sol-
vent directly over the stain.
- Rub with a clean and dry rag.
- Brush the fabric against the grain.
- Use the vacuum cleaner when the fabric is dry.
PVC OR COATED FABRICS
- Use a sponge and water and soap (household soap type).
- Dab away resistant stains with a rag soaked with white spirit, do
not rub them.
100% POLYESTER/DRALON JACQUARD
If you cannot remove the fabric:
- Clean with the vacuum cleaner.
- Clean with synthetic foam (please refer to the product instruc-
tions).
If you can remove the fabric:
- Hand wash with an ordinary washing powder at 30° C.
In both cases, dry cleaning is possible. Remove the stains as soon
as possible with a damp rag.
Interior maintenance
RECOMMENDATION
Use as few cleaning agents as possible.
Don't discharge your cleaning product into the water.
Fabrics
RECOMMENDATION
For the PVC fabrics, don't use any solvent or solvent based
product (pure alcohol, acetone, trichloroethylene).
FITTINGS
To Next Page
Loading...
