5/ Measure the job at both ends and check that it is correct. If you need to adjust the
diameter, loosen the template holder bar clamps and adjust with the fine adjustment
knobs.
Note. When initially setting up, make the job over size as you can always adjust to
make it smaller.
Note. The copy attachment is controlled by a spring and you will find that it moves
into radiuses easier than riding out of radiuses. This is especially true for small
radiuses and steep angles. It is recommended that you control the follower with the
saddle control handle so that the follower is allowed to move down the radius under
the control of the spring and you move the follower out with the control handle.
Continue this until you get to one end of the job. Then repeat the procedure from the
other end of the job.
To Next Page
Loading...
