18
WATER CHANGE
It’s possible to program after how many cycles
we want to change water completely.
A number (for ex. 1/5 according to what you have
set in the parameter) is displayed during the
washing phase. This number indicates how many
cycles lack to the beginning of the complete
water change phase.
The words “WATER CHANGE DRAIN” will be
displayed: to start this phase you have to open
the door of the dishwasher.
List of automatic MESSAGES
On the display may appear some messages to
inform about the status of the cycle start of
abnormalities. Below is the eXplanation of some
MESSAGES that appear on the display
automatically.
1-BREAK TANK :
This indicates that the tank of Break Tank is
filling of water to reach the required level.
2- BREAK TANK’S LEVELS STATE :
During the tank feeding and the rinsing the state
of the water levels in the break tank is displayed.
Symbol “H” indicates the high level, instead
symbol “L” indicates the low level.
3-ECONOMY :
After 10 minutes of non-use of the machine with
hood open, it appears the word ECONOMY.
The temperature of the heater stabililzes at 60°
reducing the consumption of energy.
4-BOILER THERMOCONTROL :
This indicates that the washing cycle will be
extended to reach the ideal temperature for
rinsing .
This message is accompanied by the value of the
temperature. This gives flashes and increments
until it reaches the programmed temperature, at
which may start the rinsing phase.
5-TANK THERMOCONTROL:
This message indicates that the wash pump will
start working only when the programmed
washing temperature will be reached.
Next to this message also the temperature value
will be displayed. This data flashes and
increases itself till when the programmed
temperature is reached. Once the temperature is
reached, the wash pump will start working.
6-REMOVE OVERFLOW :
This indicates that the overflow has to be
removed to perform the selected operations (self-
washing, descaling or discharge of the tank)
(Attention! In case of machines with drain pump,
there is no Overflow ! );
The data will disappear automatically after 10
seconds after you close the door of the
dishwasher.
7-REGENERATION IN PROGRESS :
(only for machines with built-in water softener).
It indicates that a cycle of regeneration of the
resins varying from 30” to 90” seconds is in
progress.
8- WASH OF THE RESINS :
(only for machines with built-in water softner).
It indicates that a washing cycle of the resins of
the duration of 10” seconds is in progress..
9-SALT OR PRODUCT CONTROL:
This message indicates salt lack inside the salt
container (only for dishwasher with water
softener) or liquid lack inside the descaling liquid,
detergent and/or rinse aid dispensers.
Add salt tablets or descaling liquid or detergent
or rinse aid according to the indications given by
your supplier.
This message is one-off for all 4 products.
Check which one is lacking.
10-SERVICE :
It Iindicates that you need to do maintenance
work. The scheduled maintenance service allows
you to control all the devices and efficiently
maintain your dishwasher over the time. Normal
functioning is still guaranteed. It is well worth
however not to wait too long to make the
intervention.
11-CYCLE END
COMPLETE DISINFECTION
DISINFECTION FAILED
These messages disapper only at the
dishwasher’s door / hood opening.
To Next Page
Loading...
