3
5 min
1. Wait 5 minutes after locking!!!
2. Do not open any doors during this time.
3. During this time all sensors of the vehicle switch off.
4. After the 5 minutes you can begin with the installation.
Notes to be observed during the installation!
When installing the wiring harness and the
electronics, pay attention to the following:
• Do not mount near moving parts
• Protect from vibration and water
• Do not attach the electronics to hot parts.
Preparation for installation
LOCK
1. Switch off your vehicle!
2. Open the hood.
3. Lock all doors and close your vehicle.
Do not perform the installation when the ignition is on!
To Next Page
Loading...
