Need help?Do you have a question about the LaMotte pH 5 Plus and is the answer not in the manual?
General| Brand | LaMotte |
|---|---|
| Model | pH 5 Plus |
| Category | Test Equipment |
| Language | English |
Explains the purpose of the ON/OFF, MODE/INC, CAL, and HOLD/ENTER keys on the keypad.
Details the segments and indicators on the meter's LCD display, including status icons.
Instructions for attaching and detaching the protective rubber boot and using its integrated stand.
Step-by-step guide for opening the battery compartment and installing new batteries correctly.
Identifies the low battery indicator ('LO') and advises on the procedure for battery replacement.
Guides on how to properly connect the pH electrode and temperature sensor to the meter.
Procedure for preparing the pH electrode before use by soaking it in a buffer solution.
Details the process of powering on the meter, including self-test and mode selection.
Information on performing pH calibration using various buffer groups and standards.
Detailed steps for executing a pH calibration, including buffer recognition and value confirmation.
Instructions on how to select and change the active pH buffer group (USA, NIST, Pb).
Procedure to reset all stored pH calibration data back to the meter's factory defaults.
Guidance on calibrating the temperature measurement function of the meter.
Steps for calibrating the meter's temperature reading when using the connected temperature probe.
Procedure for manually setting or calibrating temperature compensation without an attached probe.
Step-by-step guide for performing measurements, including probe preparation and sample immersion.
How to freeze the current measurement on the display using the HOLD function.
Instructions for deactivating the HOLD function and resuming normal measurement display.
To Next Page
