EasyManuals Logo

Lamtec AEC-TPS User Manual

Lamtec AEC-TPS
284 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #234 background imageLoading...
Page #234 background image
233
8 CO/O
2
Control
Fig. 8-24 Analogue measurement values window
No change or change is too small ï‚® increase P term in P 110.
NOTICE
The new correction is determined as a function of the actual/setpoint deviation of the O2 value,
the P factor and the spread factor. This is then sent to the CMS. The procedure is repeated
after the dead time has elapsed. If the internal firing rate changes during this time, the O
2
trim
switches to the FEED FORWARD CONTROL mode. The correction value follows the stored
optimisation curve.
Activating CO Control
Fig. 8-25 Open the CO controller menu
NOTICE
To open the menu at least access level 1 is required. (CMS, V1.0.3).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lamtec AEC-TPS and is the answer not in the manual?

Lamtec AEC-TPS Specifications

General IconGeneral
BrandLamtec
ModelAEC-TPS
CategoryControl Systems
LanguageEnglish

Related product manuals