To Next Page
R
Ryan CooperAug 10, 2025
What to do if my Lanaform Moa Accessories has no mist?
- YyorkchristopherAug 10, 2025
If your Lanaform Accessories device isn't producing mist, first, ensure it's properly connected to a power supply and turned on. Next, check the water level in the reservoir; add water if it's too low, or empty some out if it's too full. Also, the unit might be too cold, so place it in a room at ambient temperature for about half an hour before use. Check that the cover isn't blocked; if it is, clean it gently with a soft brush. Finally, the ceramic disc/transducer may need replacing after approximately 3,000 hours of use.
General
