18
Section 3: Adjustments
FSP500, FSP700 & FSP1000 Broadcast Spreaders 309-065M
Table of Contents
11/29/18
Distributor Vane Adjustment
Product distribution varies depending on travel speed,
radius of distribution, and roughness of terrain. Also
specific gravity, quality, and humidity of the product can
effect distribution. To help ensure even distribution, the
operator can adjust the distributor vanes to different hole
locations on the spreader disc.
Refer to Figure 3-4:
When all vanes are placed in hole #1, distribution of
product to the left is increased. If inserted into hole #4,
distribution to the right is increases.
Final adjustment of the vanes depends upon the type of
material being used and the operator’s experience.
1. Loosen M8 x 16 round head bolt (#1).
2. Rotate distributor vanes (#2) to desired hole position.
3. Tighten M8 bolts.
Distributor Vanes
Figure 3-4
24979
2
1
Hole #1
Hole #4
To Next Page
Loading...
