To Next PageTo Next PageWhat causes presence of water in oil of my Landa SDHW Pressure Washer?
The presence of water in the oil of your Landa Pressure Washer can be due to: * Worn oil seal: Check and replace if necessary. * High humidity in air: Check and change oil twice as often.
What to do if my Landa SDHW Relief Valve Leaks Water?
If the relief valve on your Landa Pressure Washer is leaking water, the valve is likely defective. Replace or repair it.
How to troubleshoot a smoking Landa Pressure Washer burner unit?
If your Landa Pressure Washer is smoking while the burner unit is running, or only smokes at a cold start when the burner is off, consider these potential causes and solutions: * Fuel Issues: Drain the tank and replace contaminated fuel. Ensure you are using the correct type of fuel. * Air and Fuel Adjustments: Readjust the air bands on the burner assembly to ensure proper air mixture. Adjust the fuel pump pressure to the specified levels. * Nozzle Problems: Replace a plugged or dirty burner nozzle. Also, replace the nozzle if it has a faulty spray pattern. Check the parts breakdown for the correct nozzle size. * Soot Buildup: Remove coils and burner assembly, clean thoroughly. Call local dealer. * Electrode Alignment: Realign the electrodes to the correct specifications. * Ob...
Why is my Landa SDHW Pressure Washer losing operating pressure?
Low operating pressure in your Landa Pressure Washer can stem from several causes: * A faulty pressure gauge: Install a new gauge. * Insufficient water supply: Use a larger supply hose and clean the filter at the water inlet and the bottom of the float tank. * An old, worn, or incorrect spray nozzle: Match the nozzle number to the machine or replace it with a new one. * Belt slippage: Tighten or replace the belt, ensuring you use the correct one. * A plumbing or hose leak: Check the plumbing system for leaks and retape them with Teflon tape. * A faulty or misadjusted unloader valve: Adjust the unloader for proper pressure. * Worn packing in the pump, worn inlet or discharge valves: Call local Landa Dealer. * Fouled or dirty inlet or discharge valves in the pump: Clean the ...
What to do if my Landa SDHW Pressure Washer burner will not light?
If the burner on your Landa Pressure Washer won't light, here's what you can check: * Fuel Issues: Ensure the tank is filled with proper fuel. If the fuel is improper or contaminated with water, drain the tank and refill it. Also, inspect for and clear any clogged fuel lines or replace plugged fuel filters. * Air and Fuel Adjustments: Readjust burner air bands for a clean burn. Increase fuel pressure to the specified level, or replace the fuel pump if it's not providing enough pressure. * Electrical Components: Test the burner transformer for a proper arc between contacts and replace if needed. Ensure all wire contacts are clean, tight, and free of breaks. Check the on-off burner switch for electrical current reaching the burner assembly. * Mechanical Issues: Replace the flex coup...
General| Brand | Landa |
|---|---|
| Model | SDHW Series |
| Category | Pressure Washer |
| Language | English |
