Laney CUB12R User Manual

CUB
2
Laney
Page
11/ 16
12
10
11
13
12
15
13
14
11
10
14
15
uses the amplifier in full power mode.
<1W INPUT: Plugging in to this input switches the output power stage down to around 1W. (Use this feature for
recording or bedroom playing).
(Always switch off and disconnect the power cord when
not in use).
SERIAL NO: Displays the model details and serial number of the unit
EXTENSION CABINET: Use to connect an 8-16 ohm extension cabinet. Please note mismatched impedance will
reduce the amplifiers performance and in some cases may cause damage to your amplifier. Try your CUB12 into a Laney
extension cabinet - you will be amazed.
MAINS LEAD: The mains lead is permanently attached so
that it does not get lost or forgotten when you transport your
amp. Stow it in the straps provided when not in use to avoid
damage.
EFFECTS LOOP: SEND/LINE OUT: Connect the input
of your external effect to this socket. This is an insert type
control, therefore all of the signal leaves the amplifier via the
`Send’ socket to be processed. This socket can also be used as a
Line Level Out. (-10dBV Nominal)
EFFECTS LOOP: RETURN: Connect the output from
your external effects to this socket. The effects loop allows you
to connect external effects such as tremolo, chorus and delay
to your amplifier. (-10dBV Nominal)
HANDLE: Laney soft grip handle for comfortable
transportation.

Laney CUB12R Specifications

General

Power	15W
Output Valves	2 x EL84
Reverb	Yes
Type	Tube Combo Amplifier
Effects Loop	Yes
Controls	Gain, Tone, Volume, Reverb
Footswitch	No
EQ Controls	Tone
Preamp Valves	3 x ECC83
Inputs	2 x 1/4" (15W and <1W input)